Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Just torqued the head down and noticed that the exposed threads above the nuts are consistent on all studs except for the last rear stud on the manifold side....seems like their is twice the number of exposed thread above the nut on that rear stud. This has me concerned. Any thoughts?
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
TR2/3/3A Cylinder head stud height question?
- Thread starter karls59tr
- Start date
Share this page
groupdeville
Jedi Hopeful
Offline
IIRC, It's to provide extra length to bolt down the rear engine lift bracket
