• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

MGB Seized air pump issue

Share this page

Celtic 77 said:
About ready to jam a wooden dowel into the air injection ports! The 7/16-20 that John Twist and others say to use are too small for my application. Off to Lowes/Home Depot with hopes and crossed fingers.
Click to expand...

Unfortunately mine is up in a leased shop space 40 miles away, otherwise I'd pull one out and see what it is for you. Knowing my luck it would strip out and not go back in.....
 
I've also seen pipe plugs in some. No post-'67 heads here so can't help with size.

And >McMaster-Carr< has about every one under the sun.
 
Grantura_MKI said:
Probably need to call in to a fastener shop like granger or the like to find the correct one.
Click to expand...
Done...7/16 20 bolt... a little long but still beats hearing the "farts" through the unplugged ports. Not pretty, but it will suffice. I can't believe how poorly it ran without the gulp valve. Reinstalled and voila, a smooth as, well as smooth as a77 MGB can be!
 
Celtic 77 said:
Done...7/16 20 bolt... a little long but still beats hearing the "farts" through the unplugged ports. Not pretty, but it will suffice. I can't believe how poorly it ran without the gulp valve. Reinstalled and voila, a smooth as, well as smooth as a77 MGB can be!
Click to expand...

If you have a tap/die set and some patience you could custom cut the bolts down to a proper fit and then clean up the threads (maybe with a copper crush washer to make a good seal - crank 'em in and call it done).
 
YakkoWarner said:
If you have a tap/die set and some patience you could custom cut the bolts down to a proper fit and then clean up the threads (maybe with a copper crush washer to make a good seal - crank 'em in and call it done).
Click to expand...
Rummaging through the garage to try locating the tap and die set... Maybe I'll be subtle and beat the living crap out of it... You know the od British car adage? Don't force it, use a bigger hammer! Right now my goal is two SU's and a Monza exhaust. I had s/s on an earlier B but I figure at 75, the Monza should outlast me!
 
If you want to make it prettier cut the head off the bolt (and as much of the shank as you need to make it the right length) and Dremel a slot so you can install it flush with the block with a screwdriver.

I was lucky when I did mine years ago. One of my customers at the time managed a fastener company and provided me with the proper size allen head set screws for free. I should have bought a hundred of them so I could give them to other MG owners in need!
 
Back
Top