• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

MGB MGB 1974 windscreen centre rod replacement

Share this page

A

Aussie Chris

Senior Member
Country flag
Offline
I recently replaced the rusty centre rod attached to the windscreen by taking off the revision mirror and drilling out the four pop rivets which allowed me to unscrew the rod and put in a new one then re rivet it back the question I have is how tight do you do up the rod?

Regards
Aussie Chris
 
Hi, Chris -

As I understand it, that rod is primarily in place to keep the top rail of the windshield from lifting when the top is secured. Probably most prudent to install finger tight, then a couple flats more with a suitable wrench. Maybe a bit of Loctite to keep it from backing out.
 
Chris, don't over tighten it, try to get the same pressure in the center as is overall. Mickey's suggestion is right on! PJ
 
Back
Top