• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A Further to brake caliper rebuild....

Share this page

K

karls59tr

Obi Wan
Country flag
Online
I just saw on the "red rubber grease" site that they pack the caliper piston dust boots with grease? I did not know this was recommended but it does make sense to keep moisture out. My concern is that with that amount of grease in there it might cause the dust boot to slip out of its slot in the piston?
Should have looked at this site before I pressed the pistons in as it shows the grease just slathered on the bore and piston. I just put a thin coat on the bore and piston?? Any thoughts?
 
I don't fill the boot with silicone grease but I .......
1643746389531.png

Sorry about the stuff below, ignore.
 
DougME said:
I don't fill the boot with silicone grease but I .......
View attachment 75599
Sorry about the stuff below, ignore.
Click to expand...
I have done about five sets now and only used a dab of brake fluid on the seal and piston before inserting the piston into the caliper. Any additional grease is just going to attract dirt that will build up on it.
Charley
 
Back
Top