TR4/4A Front Wire Wheel Hubs Differ from Disc Hubs??

[KVH]

Gosh, I sure never noticed. How are the two hubs different? I thought the only difference was the length of the studs.

 

[JerryVV]

Only difference is the length of the wheel studs

 

[TR3driver]

The hubs came with the studs already installed, so the part number for the assembly is different. But like Jerry said, the hub itself is the same.

 

[JerryVV]

The hubs came with the studs already installed, so the part number for the assembly is different. But like Jerry said, the hub itself is the same.

Well that makes sense, you need to remove the rotor and with a good whack the wrong studs come out and then pull the right ones in with a nut and some washers, Bob's your Uncle.

 

[Geo Hahn]

...with a good whack the wrong studs come out and then pull the right ones in with a nut and some washers, Bob's your Uncle.

And then you can move on to the rear... and that's a whole 'nuther story.

 

[JerryVV]

And then you can move on to the rear... and that's a whole 'nuther story.

If an IRS car they're easier than the fronts, solid axle in your words 'nuther story for sure.