CJD
Yoda
Offline
Got the TR2 running, but that highlighted a couple issues.
I have a leak from the control shaft where it enters the solenoid plate. This is the shaft that goes crosswise through the overdrive, and the solenoid turns it to activate the OD. Since I rebuilt it 3 years ago, I have no memory of any seal for that shaft. In my pics, it doesn't appear there ever was a seal on the shaft.
Has anyone had a leaky shaft? If so, how did you seal it? All that comes to mind looking at it would be to install an exterior "o" ring between the plate and the actuating arm that clamps to the shaft?!?
I have a leak from the control shaft where it enters the solenoid plate. This is the shaft that goes crosswise through the overdrive, and the solenoid turns it to activate the OD. Since I rebuilt it 3 years ago, I have no memory of any seal for that shaft. In my pics, it doesn't appear there ever was a seal on the shaft.
Has anyone had a leaky shaft? If so, how did you seal it? All that comes to mind looking at it would be to install an exterior "o" ring between the plate and the actuating arm that clamps to the shaft?!?