Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
charleyf
Luke Skywalker
Offline
I am working on a TR6 wiring harness bought from Moss 4 years or so ago. I am having trouble with the screw in type bulbs. The bulb holder is a cylinder with two opposing grooves that are supposed to provide the grooves to thread the bulb into. Problem is that they aren't working. Tech at Moss sent me some of their bulbs that "might"be a bit smaller. I got a couple in but once in they are able to pop back out with a little jostling. As these harnesses have been out there for several years, I am asking if anybody else has a "fix" for this.
I found that the bulb thread is about the same as a 3/8" course thread. I tried improving the grooves with both a bolt and a tap. This gave me no improvement.
Any ideas? The only other option I have seen is cutting off all of the bulb holders and using the ones from the old harness.
Charley
I found that the bulb thread is about the same as a 3/8" course thread. I tried improving the grooves with both a bolt and a tap. This gave me no improvement.
Any ideas? The only other option I have seen is cutting off all of the bulb holders and using the ones from the old harness.
Charley
