Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Anybody have a clue as to the installation of a wiper motor park switch? I am guessing it mounts to the wiper motor itself due to the small plunger type pin on the new park switch. When I connect the wires to the switch the wipers run...when I manually push the plunger in on the switch, the wipers shut off.
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
TR6 wiper park switch-tr6
- Thread starter Wike
- Start date
Share this page
TR3driver
Great Pumpkin - R.I.P
Offline
That's the way I remember it; just two small screws that hold the switch to the side of the gearbox. The little plunger sticks through a hole and rides on the big gear.
But it's been awhile since I was inside a TR6 wiper motor, so the exact details are fuzzy.
But it's been awhile since I was inside a TR6 wiper motor, so the exact details are fuzzy.
After looking at several views found in the Rimmerbros website under wiper motors, it was sort of clear that the park switch I was trying to figure out was located on the underside of the wiper motor...the plunger goes in to the motor gear via a small hole while the other end, which has a plastic peg, fits into a small hole. The trick is getting the small clip attached to the park switch which holds the switch to the motor to engage in the slot on the wiper motor while getting the prior to line up. I found by prying the clip open just a bit worked. Thanks all for the help