Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Just put the 3 on the road after doing a front end rebuild....noticed that the drivers side wheel is now viibly toeing out.After searching my garage I found an older Manco wheel alignment kit that I bought from Moss or TRF many years ago but dont have the instructions. Anyone have a kit like this? It's basically an aluminum bar with a degree gauge mounted on it.
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Wheel Alignment Tool by Manco...no instructions
- Thread starter karls59tr
- Start date
Share this page
KVH
Obi Wan
Offline
I have one, and I have the instructions. I need about an hour to hunt it down. I'll post it or email it to you.
It's easy. You need a good wrench to avoid stripping the tie road securing nuts.
Also, on mine, I had to sort of "crunch" the little bar stands down a bit since the TR4 is lower than many other cars that the bar is made to work with.
You start by placing the bar behind the two front tires. You then raise the car and make any necessary adjustment; then lower it and see how you did. The gauge has some funny "times 2" aspect to it since you're, of course, dealing with two tires.
I'll find it.
It's easy. You need a good wrench to avoid stripping the tie road securing nuts.
Also, on mine, I had to sort of "crunch" the little bar stands down a bit since the TR4 is lower than many other cars that the bar is made to work with.
You start by placing the bar behind the two front tires. You then raise the car and make any necessary adjustment; then lower it and see how you did. The gauge has some funny "times 2" aspect to it since you're, of course, dealing with two tires.
I'll find it.