• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

MGA What does this founder mark mean?

Share this page

B

Bob Branson

Member
Country flag
Offline
1600 engine down to bare block, and after scraping the block surface where the head gasket sits, I find stamped into the machined surface off toward the edge and between each cylinder, a diamond with the numeral three. Is this from the factory, or perhaps from a previous rebuild and a trip to the machine shop? TIA.
 
Bob, I think its explained in the factory shop manual to match the same marked pistons with the bores . The engine blocks were probably finish honed at one station then measured and marked with these code numbers. Pistons from another station were also finished then measured and marked with codes also on their tops. That way the assembling mechanic would only need to match the same codes ( not remeasure and fit each piston to its bore) making assembly much faster.
 
Thanks, you must be right. The block had been bored .030, and the three by each cylinder was probably an indicator of the oversize of that bore. Duh!
 
Brinkerhoff said:
I don't think the 3 inside of a diamond has a thing to do with a re bore to .030 over, just a coincidence.
Click to expand...

Correct. The 3 had to do with the measurement of the bores and which pistons would be the best fit - we are talking less than 0.001" increments here. The assemblers just looked at the mark and chose the best pistons from their stack; the bore measurement had been done and stamped by the guy that finished the cylinders.
 
Back
Top