• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR4/4A Wanted: TR4A PCV Valve Bracket

Share this page

CinneaghTR

CinneaghTR

Jedi Warrior
Offline
Hi All,

I need the bracket (Stanpart 143313) for the PCV valve assembly on a TR4A. If anyone is willing to part with one, loan one so I can replicate it, or provide detailed measurements, it would be greatly appreciated.

/ubbthreads/images/graemlins/hammer.gif

I would also be willing to buy the entire assembly if needed.

TIA,
Jeremy
 
Jeremy, the bracket is made from mile steel and is rounded on the ends where the holes are. The bottom hole is 3/8" the top 1/4", drill these first. The width is 15/16" the first bend off the manifold is 1 1/2" then 2 inches streight then 1 inch, so 3 1/2 inches plus about a 1/4 inch for the two bends. You should end up with a 1 1/4 inch bend over all. Hope this will help. Wayne
 
Let me dig through my pile-o-goodies.. I may have one. If I do, I'll send it to you for whatever it costs to ship it. Just give me a day ot two to go digging (unless someone else comes up with one) as it's buried in the back of the shop if I have it.
 
Back
Top