• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

MGB Trunk lid..[boot] alignement

Share this page

brcree

brcree

Freshman Member
Offline
Just replaced my trunk seal (on trunk) on my 73 "B". Now....the lid wont latch, any suggestions?:cool:
 

Attachments

  • Penney 005.jpg
    Penney 005.jpg
    182.6 KB · Views: 147
I don't have a suggestion but my daughter goes to Wofford in Spartanburg. Other than my rubber bumpers our cars would be a match. Maybe I will pass you sometime down that way!
 
I think it's been documented in the past that the seal/gasket that fits on the trunk lid is too thick. I know mine on the 74.5 makes the lid stick up higher than the shell height by 1/16+ especially in the corners.
 
Check Moss' website for the "compressable" seal. It's a hollow version.
 
Ended up removing seal to lid type and, went with the body mount type. Much better. All is well now.
 
Back
Top