Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
mrv8q
Luke Skywalker
Offline
Has anyone tried the TRF kit for seatbelt replacement? These replace the Kangol inertia belts. Here is a pic of the mounting points on the TR6:
Here's a pic of what comes in the TRF kit:
When I got the car, the original seatbelts were in the trunk. I'm guessing the the short part of the belt goes into the large bolt hole in the floor, inboard of the trans tunnel. That leaves 2 mounting holes on the long belt. I'm guessing the end attaches to the bolt at the bottom of the "B" pillar. The remaining mounting point w/ the plastic cover would go to one of the two mounting points on the rear wheel arch......
Thanks for any help!
Here's a pic of what comes in the TRF kit:
When I got the car, the original seatbelts were in the trunk. I'm guessing the the short part of the belt goes into the large bolt hole in the floor, inboard of the trans tunnel. That leaves 2 mounting holes on the long belt. I'm guessing the end attaches to the bolt at the bottom of the "B" pillar. The remaining mounting point w/ the plastic cover would go to one of the two mounting points on the rear wheel arch......
Thanks for any help!