• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR6 TR6 Master Cylinder

Share this page

L

LBC_TR6

Freshman Member
Offline
I am trying to "rebuild" the master cyclinder of my '74 TR6, but the secondary plunger will not come out. Is there a way to remove it? I have tipping valve, primary plunger and intermediate spring removed. Thanks.
 
a good whack on the bench, or some compressed air in the outlet.
 
wheni did mine i spent quite a bit of time trying to get the plunger out...till i noticed a second internal snap ring ....wwwwaaayyy down inside the bore....my not be applicable to yours ..but be sure to take a good look
 
Back
Top