• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR6 TR6 dismantling ?

Share this page

C

crj7driver

Jedi Trainee
Offline
I am in the process of tearing my TR6 apart for a frame off restoration. As I was tearing out the dash and wiring harness I couldn't imagine how to get in and media blast/paint the area that houses the wiper armatures/air intake.

Luckily there does not appear to be any rust in there, so without cutting sheet metal, what is the best way to deal with that area?

Also, I am going to take the fenders off this weekend, any suggestions?

Hopefully the body will be off the frame next week.

Thanks
 
I dismantled my six completely for its restoration. Removing the body wings (fenders) is a snap. Just remember to get all the bolts, along the top edge, the bottom rocker and the vertical mounting just fore and aft of the door opening. It might be a little sticky during removal because there is body joint compound between the inner and outer fender panels.
 
Back
Top