• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR2/3/3A TR3b windshield parts

Share this page

T

TFB

Jedi Knight
Offline
Trying to finish my windshield assembly and am in need of the lower rubbber seal finishers(2) for late model bolt on stantions.These are larger than the earlier type finisher clips.
If anyone has a set to sell or can recommend a vendor I would appreciate it.I have Dzus type stantions and finishers to trade if interested.
Thanks
Tom
 
FWIW, those finishers are not visible once the assembly is on the car. Faced with a similar problem many years ago, I just cut some from a piece of stainless steel sheet I had laying around.

The fun part was duplicating those funky little screws. ISTR I managed to find some pan head sheet metal screws that were close to the correct diameter, and cut them to length.
 
Thanks Randdall.I would probably consider making if it was keeping me off the road,but my project has a way to go so hopefully some will turn up.I may contact some of the usual ebay sites.
Also,I hadn't even thought about special screws,thinking they where just round head 10/24.but now after looking closer ,it does look like a sheet metal thread,unless its some thread type I am not familiar with.

thanks
Tom
 
Back
Top