• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A TR3A Sheet Metal Piece Needed

Share this page

T

tedwone

Senior Member
Country flag
Offline
If anyone is carving up a TR3A body and has a good or repairable lower portion of the left side (driver side) quarter panel (dog leg), I need about 5" from the bottom of the body from the door pillar to the wheel arch.
 
Somebody gave one away a few months ago, but they are fairly rare. They all rot in the same place. That lower piece is not too hard to make if you have some basic panel beating skills.
Tom
 
Hi, I made two that were 4" tall. I made the bend around a 1 3/4" diameter tube, then used a cardboard pattern for the final shape. From what I could tell the bottom 4" are about straight. Not sure about 5".

Roy
 
Back
Top