• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A TR3 Turn Signal Lights Install

Share this page

O

oxendine

Jedi Hopeful
Offline
Been trying to finish my 1960 TR3. Bought new front and rear turn lights. The wires seem to go into the bases using bullet type connectors but when I tried that route they stuck out too far and he base would not go into the rubber boot. The connectors sit perpendicular to the base. This seems wrong. I ended up soldering the wires on the first one I did. Not gone any further yet awaiting a better idea?

Thanks, Donnie
 
They were perpendicular originally as well.

Mine were a snug fit, but I kept the bullet connectors. Had to turn them a bit as I recall and put a sharp bend in the wires. The rubber boot should stretch a bit to fit over, then you'll have to work it back and forth to get through the hole in the body/grill.
 
Back
Top