• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
  • When posting a classified ad, you MUST select a prefix from the drop-down next to the subject line. If you don't you will get an error and your ad will not be posted!
Tips
Tips

TR2/3/3A TR3 rear shock link question

Share this page

M

Mkutz

Jedi Hopeful
Country flag
Offline
Hi Guys -- I have a question about the nylock nut that attaches the shock link to the spring plate. The question is is how tight should it be? Recognizing that it is a nylock, should it just snugged (say 10 foot pounds or so) to allow the link and the spring plate to articulate in motion or should it be locked down solid-tight?

Thanks for any input.
 
Sock 'em down. There is plenty of movement allowed with the rubber inside the links. I don't remember if they are 5/16", or 3/8" nuts. If 5/16", 16-18 lb/ft...if 3/8", 26-28 lb/ft.
 
:iagree:
Any movement in that joint is going to wear things out in a hurry, so you want it locked.

According to the book, it's a TN3210, which is a "thin" 7/16 NF Nyloc and it should have a flat washer.
 
I would definitely use a torque wrench. I just had a Moss link's upper bolt strip on me, the pin/bolt threads just disintegrated under much less the torque than what I expected, using a 3/8 ratchet.

FWIW, the TRF links I purchased to replace seem much better quality.
 
Back
Top