• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A TR3 Master Brake Cylinder Stripped Fitting

Share this page

J

jflynn

Freshman Member
Offline
I rebuilt the master brake cylinder of my 1959 TR3 but I fear I have stripped the female threads where the brake line mates with the cylinder. I'd try retapping it if I knew the right size thread. Anyone know the right size? Any other ideas?
 
Jim-

This may not be right as I have a TR4, but on my setup the fittings are 3/8-24. I know because I was worried I did the same thing when I crossthreaded the brake line fitting to the cylinder.

Good luck
Randy
 
Back
Top