-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR2/3/3A TR3 front air vents mounted under the grill...seen on race cars for better air flow to radiator.
- Thread starter karls59tr
- Start date
Share this page
Online
Karl
Typically the under grill vents are to oil cooler that some mount under the rad mouth
These are typically DIY fabricated
The round ones are via hole formers that give a tidy radius like this
www.carbuilder.com
Typically the under grill vents are to oil cooler that some mount under the rad mouth
These are typically DIY fabricated
The round ones are via hole formers that give a tidy radius like this
51mm (2") Sheet Metal Hole Punch
Never again struggle to cut a nice round clean hole through a panel. Our range of hole cutters will cut a neat, distortion free hole in mild or stainless steel up to 16 swg (1.6mm) or up to 2mm in aluminium, copper and brass. Simply drill a pilot hole, assemble the punch and wind it through with...
www.carbuilder.com
