Ready to instal my cowl vent and can't recall how the spring goes. Rubber seal first (does it get any adhesive?). Then two screws hold vent hinge. Then two screws through the cowl into the nuts on the pivot. But what does the spring rest against? Pictures would be helpful-thanks.
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
TR2/3/3A TR-3A Cowl vent assembly/spring
- Thread starter Arrow
- Start date
Share this page
luke44
Jedi Warrior
Offline
Between these 2 threads you should be able to find the answer. I didn't use any adhesive eon the seal.
https://www.britishcarforum.com/bcf/showthread.php?67924
https://www.britishcarforum.com/bcf/showthread.php?71503-TR3-Scuttle-Vent-Assembly
https://www.britishcarforum.com/bcf/showthread.php?67924
https://www.britishcarforum.com/bcf/showthread.php?71503-TR3-Scuttle-Vent-Assembly
TR3driver
Great Pumpkin - R.I.P
Offline
I find it easier to disconnect the linkage from the lid, and install the linkage first. The spring gets trapped between the bracket that carries the linkage, and the body. Install the gasket & lid; then connect the spring & linkage to the lid. Here's a couple of photos
https://s258.photobucket.com/user/TR3driver/library/TR3 Vent installation
https://s258.photobucket.com/user/TR3driver/library/TR3 Vent installation