• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Torque settings?

Share this page

B

burgundyben

Jedi Hopeful
Offline
The manual I have refers to castellated nuts for the mains and big ends and says you should tightend and then on some until you can get the split pin through. It does not give a torque setting.

What is regarded as right for the bottom end of a BN1 engine?

Thanks

Ben
 
Hi Ben,
I have never seen a published number.
If the main studs are the same size as the cylinder head studs, 7/16", 65 to 70 ft/lb should work.
D
 
Yeah Ben, DR guessed pretty close: Main Bearing Nuts =75 FT LBS.
--Connectng Rod Set Screws = 50 FT LBS.

Fwiw---Keoke
 
Back
Top