• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Top to windshield side pillar mount.

Share this page

R

robert_ellison

Jedi Trainee
Offline
On my BJ7 the convertible top mount hook, connected to the side pillars, is attached by 2 rivets. As mine were rusted I thought it a simple matter of drilling out the rivets. re-chroming the parts and reinstalling. However, after drilling out the old rivets I took the side pillar apart, only to find that there is no interior open space to run a new rivet. The space directly behind the place where the back of the rivet would be is filled by an interior stiffener bar which leaves no room for a rivet, unless one would drill down into the stiffener bar on it's edge and somehow thread it to accept a screw.

I am bewildered as to how to re-mount the hooks.

Suggestions greatly appreciated.

Robert
 
Robert,

I think (but might be wrong) that you can unscrew the screws that are tapped into the stiffening bar (i.e. it's only screws holding it in .. no rivets). Once you remove the stiffening bar you can get to the inside to set the hook rivets. Let me know what you find.

edit: actually now that I think about it more, I do think the lower part of the stiffener has rivets. You still may be able to loosen the screws and pry the stiffener up far enough to set the hook rivets but it will probably be a pain.

Cheers,
John
 
Back
Top