Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
OP
EWD
Jedi Hopeful
Offline
Re: ‘74 TR6
Hi folks! After 2 years, finally on the road; but it‘s getting cold.
So, in the middle of installing a new top.
Question: I have glued the rear edge to the back bar and installed the snaps. Getting ready to attach bar and I noticed that, when putting the top down, I could not fold the side panels over the rear window without creasing the side window. In order to fold the panels along the seams, which allows the panels to fold naturally and without damage to the windows, the back vinyl edge cannot be glued all the way to the edge of the metal strip (gluing ends at the point of the last snap just under the strap). Is this correct, or am I missing something? Thanks as always. Hope my question is clear.
Best -
Will
Hi folks! After 2 years, finally on the road; but it‘s getting cold.
So, in the middle of installing a new top.
Question: I have glued the rear edge to the back bar and installed the snaps. Getting ready to attach bar and I noticed that, when putting the top down, I could not fold the side panels over the rear window without creasing the side window. In order to fold the panels along the seams, which allows the panels to fold naturally and without damage to the windows, the back vinyl edge cannot be glued all the way to the edge of the metal strip (gluing ends at the point of the last snap just under the strap). Is this correct, or am I missing something? Thanks as always. Hope my question is clear.
Best -
Will
