• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

To Notch...Or Not To Notch

Share this page

jhorton3

jhorton3

Jedi Warrior
Country flag
Offline
When the glass shop reassembled my windshield he left the windshield frame to body rubber gasket a bit long on either side. They extend under the A pillars. Is this the correct way they should be, or should I cut a notch out of either side so the gasket fits snugly around the bottom of the A pillars?
 
Allowing the windshield to cowl rubber to go under the pillers will not allow the pillers to fit.

Be very careful how much you trim. should be snug to the piller but not under it.
 
Measure twice, cut once etc etc...
 
Heck cut several times starting with too long.
 
Back
Top