Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I just bought a 1968 spitfire & the previous owner replaced shocks and springs. When I hit big bumps the tire rubs the wheel well. Car has wire knock offs so I don't think it's due to over sized tires. I'm thinking about adding a spacer on the shock to shorten the travel. Has anyone else experienced this issue? Thanks!
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Spitfire Tire bumps wheel well on spit mk3
- Thread starter 68umph
- Start date
Share this page
Offline
What part of the wheel well is the tire rubbing? I don't think a spacer will help; rather, it would only change the ride height a bit but probably wouldn't make enough of a change in geometry or travel. (This is in front, correct?)
Rhodyspit75
Jedi Knight
Offline
Are these factory wire wheels or something aftermarket? Also you say the PO changed the springs, could be he dropped the front lower.
Simon TR4a
Jedi Knight
Offline
If it touches over a bump I would expect there would be a visible problem with ride height, i.e. low at the front.
Springs hold the car up, not shocks- see if you can see if the coils have been cut, or remove a spring and check the free height against the specification.
Using spacers is a makeshift solution.
Springs hold the car up, not shocks- see if you can see if the coils have been cut, or remove a spring and check the free height against the specification.
Using spacers is a makeshift solution.