• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Timing Cover Gasket Replacement

Share this page

KVH

KVH

Obi Wan
Silver
Online
I thought I was being so careful. But I got the cover off kilter a bit while fitting it, and then couldn't realign the gasket once it was full of gasket goop. I ended up tearing the whole thing off and starting over. I really made a mess. I had to wash all the sealant off with lacquer thinner.

Is there an easy trick to this. Like four hands?
 
I opted to go without the gasket goop. It took extra time to clean the surfaces so no residue was remaining from the old gasket. I am quite pleased to report that I don't have any leaks, at least not around the timing cover.
 
If you use a sealer, such as Red Shellac, do only one side and allow it to dry to the cover for a day or so. Then it won't move when you try to position it.
 
I know this has been asked time and again, but would Blue RTV and any decent silicone sealer be good for that cover?

I also have a bottle of Permatex "High Tack" and that's what I used on the timing cover I messed up. Maybe I should use that again but apply it to the cover and gasket only, and dry it for a day?
 
<div class="ubbcode-block"><div class="ubbcode-header">Quote:]but apply it to the cover and gasket only, and dry it for a day?[/QUOTE]

That worked well on my chrome cover.
 
Back
Top