• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A Throw out bearing

Share this page

O

Oldpine47

Freshman Member
Offline
I had my transmission rebuilt and somewhere along the line I lost/misplaced my throw out bearing. The Roadster Factory lists one on page 11 that fits all model TR2 & Tr3 Triumphs. I am pretty clueless about transmissions and clutches. Can anyone tell me if this is what I need or where I can get the correct one?

TIA
Fred
 
The bearing and the sleeve are separate part numbers. You might be missing both. Make sure the pin is tight on the shaft. Tom
 
That's the right one, as long as you still have the original clutch. The TOB did not change until the TR4A was introduced, with the diaphragm clutch instead of the old 3-finger one. Like Tom said, you'll probably need the sleeve as well, PN 100159.
 
Back
Top