• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Thermostats

Share this page

rlich8

rlich8

Jedi Trainee
Offline
Hi All,

I recently installed a new modern thermostat in my car. There was a modern one in there already, but it looked kind of ratty so I decided to replace it.

My question is this. The design of the bypass hose presumes that we're using a Bellows/Sleeve-style thermostat. Obviously, I am not. I'd rather not use the old style thermostat because they are prone to failure. So, I should block off the bypass, correct?

What should I do this with? I tried the auto parts store to see if they had rubber radiator hose caps in 1", but they didn't. I ordered some caps from McMaster Carr, so we'll see if those work. If not, what would someone suggest? I want to make it look nice, and as clean as possible.

All ideas welcome! Thank You!
 
I believe Geo wrote that he found a copper pipe cap that would slide snugly inside the bypass hose. Drill whatever size hole you think is appropriate.

I went a different route, and tapped the water pump housing for a pipe plug (1/4" IIRC). Then, since some water circulation is essential even with the engine cold, I drilled a 1/4" hole through the thermostat backing plate (so a small amount of water can always circulate through the radiator. That might not work for you if you drive in the winter, but I've not had a problem even in temperatures below 40F.

PS, the factory did not use a sleeved thermostat in the TR4A. The bypass is already somewhat restricted by thermostat housing (unless someone has swapped your housing for an earlier one).
 
I believe I have the correct housing, although, there is some amount of bypass allowed with this housing. I read over on M**s Motors website that if using a modern thermostat, the bypass should be blocked. But according to what you're saying, maybe it's not necessary at all to do this.

I thought of tapping the pump housing, actually, but I figured the caps would be easier and still look clean.

I'll test it out with the bypass hose and without. I may never even see a difference. Thank You!
 
rlich8 said:
I may never even see a difference.
Click to expand...
That's pretty much been the result of all my experiments.

Not very good, but maybe you can see the difference in the housings :

DSCF0011crop.jpg
 
I see what you're talking about now. 2, 3, 3B, 4 on the left, 4A on right.

I'll see what happens. It won't hurt. :smile:
 
Back
Top