Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Upland
Member
Offline
I have been rebuilding the front suspension on my Mk IV. New pans, fulcrum pins, hardware and SuperPro bushings. I have an issue with the trunnion bushings. The SuperPro bushings come with 2 washers, when I put the washers in the the cut out in the fulcrum pin will not line up with the shock arm set bolt hole. The set pin can not go in. If I remove the washers it fits just fine. Question, if I extend the fulcrum pin cut out by approximately .25” the set bolt goes through the cut out and into the shock just fine. Which is the better choice? Have the washers on the ends of the bushings, (the original rubber bushings have metal washer/top hats) or no washers and not have to extend the cut out in the fulcrum pin. Your thoughts will be very appreciated.
Upland
Upland