Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Any recommendations and/or best practices to follow when installing the steering arm onto the rocker shaft in the correct orientation? This is for a AH 3000 B7 that needed a new steering box so the steering arm is not indexed. Perhaps this would involve counting the number of rotations lock-to-lock then turn box half that number to center the rocker shaft. Thanks all.
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Steering Arm Installation Recommendations - BJ7
- Thread starter gonzo
- Start date
Share this page
Offline
I thought the steering arm could only be installed in one of four positions at 90 deg from each other.