• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Spyder-Mite Update

Share this page

CARSINC

CARSINC

Senior Member
Country flag
Offline
The interior panels and carpet are mostly installed. These parts came with the car when I purchased it and were sourced by the previous owner from Moss Motors. The panels fit fairly well but the carpet needed a lot of trimming and shaping. If I were buying today I'd source from Bugeye Guys. I glued the carpet in except for the foot wells and transmission tunnel where I used velcro. Since this will be a Spyder version there will be no roll up windows or vent windows and the windshield willbe chopped two inches. The openings on the doors have been covered. Next week the dash comes out to complete the wiring and all new instruments from Speed Hut.
 

Attachments

  • 20230928_160008.jpg
    20230928_160008.jpg
    1.5 MB · Views: 122
  • 20230928_155918.jpg
    20230928_155918.jpg
    1.7 MB · Views: 128
  • 20230928_155750.jpg
    20230928_155750.jpg
    1.9 MB · Views: 119
Headlight buckets and trim have been installed. Although everything has been installed properly, I'm not entirely satisfied with the gap between the trim rings and the body.
 
Back
Top