Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I need to know who makes the best release bearing for 1275 sprites. I've replaced 2 in the last 2 years with almost no driving miles. About 100 mi on the first and 400 on the second. Both were from VB. On the 2nd one I built my own push rod so I know it was adjusted correctly. Defective parts? We owned a sprite in the 60s and never had a problem with this, drove it many miles and it was fine when we sold it in l969. Any help/hints will be appreciated. JSM
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
sprite clutch release
- Thread starter owby
- Start date
Share this page
Gerard
Luke Skywalker
Offline
It's hard to know who makes/supplies the reproduction stuff these days. You figure most of it some from the same suppliers. AH Spares in the UK is known for having better quality replacement parts, so I would check with them and see what you can find out.
I've been putting 5 speeds in everything, so I haven't bought one of those in years.
https://www.ahspares.co.uk
I've been putting 5 speeds in everything, so I haven't bought one of those in years.
https://www.ahspares.co.uk