• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Spitfire Spitfire carb question

Share this page

D

Dono

Senior Member
Offline
Greetings Spit-heads,
I'm finishing reassembly of a 1971 MkIV 1296cc Spitfire. The carb has been prof rebuilt but runs poorly. Choke on it runs barely, idling at 2200+. Timing is correct, new electronic ignition is strong, fuel pump okay.
Question: It has a B5AV which is the correct needle for a spitfire 1300. The engine is a '69 MkIII 1296cc. Anyone know of a needle size & source for a richer needle?
Thanks! Dono
 
B5AV is pretty slender overall. I suspect there is another problem.
 
I too have a 71 MKIV.
And chased a problem like yours for a while.
Turned out I had a major vacuum leak at the intake to engine gasket.

Have you checked, listened, or sprayed carb cleaner around?

I could close off the entire carb throat with my hand and she would rev dangerously high.

I had to re-seat the manifold and it settled right in. The nuts UNDER the intake are a PITA. Be sure your manifold clasps ( can't think of what they are called right now) are seated correctly or they only hold loosely.
 
TD -
Good call. Pulled the intake manifold, found a small piece of cra- that had stuck to it when installed 18 mo ago. Re-torqued the nuts, including the PITA ones below and POOF, I'm running closer to normal. Still have to tweak it some but I found the nemesis w/in the system - a basic one......once again. Thanks for all comments! Dono in Missoula, MT
 
One more comment. The needle is is the richer needle, B5AY. The B5CH is for leaner sitchs, like I have at 3600' elev here, but I'll work w/ this for now. Don
 
B5AY, not B5AV?
Joe Curto, THE carb specialist had advised B5AV, then later B5AY; so I'll go with the corrected expert opinion. B5AY also matches the TR manual page diagrams.
Thanks, Dono
 
Dono.., I'm not disputing anyones opinion. I was just trying understand the change.
 
No worries. I didn't mean to sound too aggressive, merely that Joe is "the" expert. He senses problems others cannot. He's amazing and I was glad to share my story. Dono
 
Back
Top