• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Speedbleeders for Clutch Slave Cylinder

Share this page

MadRiver

MadRiver

Jedi Knight
Country flag
Offline
Howdy all:

Going to tackle my clutch slave cylinder in the near future. Anyone happen to know what size Speedbleeder will fit a TR250 slave cylinder? Same as the brakes?

Thanks!
 
Re: Speed-bleeders for Clutch Slave Cylinder

Aloha Bill,

The TR3 uses 3/8 x 24 for all the brake and clutch hydraulic connections. the part number is SB3824HD or SB3824HD SS in stainless steel. I suspect the the same applies for all the TRs through the TR6. I addition to speed bleeds, I recommend you get their bleeding bag, it is like an IV bag. It is clear, lies flat under the car, an not tip over and is sealed so the fluid bled into it won't be contaminated by dirt, etc.
 
Re: Speed-bleeders for Clutch Slave Cylinder

You can picked them up at NAPA too. Different part #. Just go in and cross reference them. Have 1 on both the 6 and the 8.
Never heard about the bag though. Nifty!
 
Re: Speed-bleeders for Clutch Slave Cylinder

Thanks guys! I'm a huge believer in the product, and have them on the brakes for the 250 and Tiger -- haven't done the other cars simply because I haven't gotten around to it. Just couldn't recall the size! :smile:

I too recommend the product to one and all.

B.
 
Back
Top