Slave Cylinder

[AngliaGT]

I'm looking for a Lucas Girling 1-3/8" OD
slave cylinder to fit my Cortina.
It has an adapted AP Lockheed cylinder on there now
with the part number Q110 on it.Does anyone know what
vehicle(s) this would fit?I've been told by my parts supplier that the Girling one is NLA.So that's why I'd like to find out where I can get a Lockheed replacement.

- Doug

 

[Dan_Morrison]

Hey Doug,

That slave sounds really large. I think the stock slave cylinder is only 7/8" diameter. I think it's the same one that comes on the Lotus Seven (S4 anyway) and Cortina. I just rebuilt one for my Seven and I'll double check, but think it was 7/8". As for availability, check eBay, Dave Bean ($$). Also check British Parts NW (https://www.bpnorthwest.com/.sc/ms/dd/ee/6387/Clutch Slave Cylinder Lotus Elan ).

Good luck,
Dan

 

[AngliaGT]

Dan,

The outside diameter of the slave cylinder casing,
where it goes through the hole on the transmission case,
is 1-3/8".

- Doug

 

[AlanT]

I sold the three I had on ebay about 5 months ago. All went back across the pond. The girling part # is 64068397.
Alan T

 

[AngliaGT]

It's always "last week/year" etc.....
It seems that I'm always just a little bit too late.

- Doug