• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Silicone Valve Cover Gasket Installation

Share this page

Michael Oritt

Michael Oritt

Yoda
Silver
Country flag
Offline
I recently bought a "Gasket Innovations" silicone valve cover gasket, the section of which is roughly D-shaped.
The website instructions say that for an aluminum valve cover with a flat flange (which is what I have) either side of the gasket may be glued to the cover.

My instincts tell me to attach the flat side of the gasket to the cover flange so as to allow a bit more surface area for bonding, but I would appreciate knowing others' experiences as well as adhesives used.
 
I installed one on my TR-6 last year. I put the flat side toward the valve cover. Don't use too much sealant. Just a continuous bead all the way round. After I put the silicone on, I placed the valve cover, face down on a flat surface with a few pieces of masking tape holding it here and there until the silicone set up a bit. I torqued the cover down lightly with a torque wrench according to specs. It has not leaked yet. Have fun...J.D.
 
My go-to to for affixing gaskets to valve covers, at least cork ones, is 3M Upholstery Glue (aka 'yellow snot,' though it comes in black). Should work on silicone too, and 3M Adhesive Remover to clean it off (works so well they banned it in California).
 
Trouble with that stuff is that it becomes hard as a rock. I worked in Volkswagen garages back in my youth. 3-M yellow snot was common practice on the VW valve covers. We used to clean it off on the wire wheel. When I bought the TR in 2023, first order of business was to get rid of all the leaks. It has been quite the "crusade" but she is dry now. Hope it stays that way. ...J.D.
 
Thank you all for your input. I agree with WW that the yellow peril can sometimes harden to the point that a cork gasket gets destroyed in the process of removal. I was thinking about using the blue Hylomar or equivalent which remains relatively flexible.

My valve cover is one of the early AL finned models and I am waiting for a replacement badge which is riveted to the top of the cover so I will probably not get around to the installation for about two weeks, but I will definitely post the results
when the install is finished.
 
I don’t have the aluminum valve cover but I did use the silicone gaskets on the valve and side covers . High temp silicone used sparingly to hold the gasket in place with additional masking tape in a few places . Tighten I’d down gently and only tighten it a bit more if it leaks .
 
I also have a 1/4" drive torque wrench that measures in inch pounds for jobs like this. ...J.D.
 
Back
Top