Securing the cockpit side fuel tank closeout

[ekamm]

In this picture you can see the brackets that the panel closing in the fuel tank fit in. If you look in the middle you can see an indention where I removed a similar bracket that was attached with a screw. There was also a hole in the mill board that I recovered. Is that bracket to be secured with a screw to both the body and board in eventuality?

 

[tdskip]

Wait - there was a screw going into / using the gas tank as a securing point?

 

[ekamm]

No the pic shows 6 brackets and there is an indention and a hole in the center of the area covered by the capping. I found a better picture,at the very top ou can see the indention.