TR2/3/3A seat runner placement

[deuce]

Hello folks.. first, thanks to all for help on my tr3a build. Been almost 5 years (and counting) .. can it be? Anyhow, I'm looking at setting the seat runners. I replaced the floor pans. Is there a starting point..ie, parallel to the sills, x inches from the rear seat riser, x inches inside the bottom rails. I got the runner kit from TRF. Ok, I measured the holes in the seat pans.. 11 inches center to center. That helps a little but still a reference to set the first rail. Thanks, George

 

[CJD]

There should be pre-drilled holes and caged nuts under the floor, limiting the placement of the rails. The single most important thing to ensure is that the rails are absolutely parallel to one another.