• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Replacement Bushings for A-Arms

Share this page

Jim_Gruber

Jim_Gruber

Yoda
Country flag
Offline
Folks NFI- Just passing on info I found.

Jim,

$36 for set of four bushings, plus $6 for postage.

Lazar
Apple Hydraulics
https://applehydraulics.com

On 11/6/2010 12:33 PM, James Gruber wrote:
> Could I get a price for a set of bushings to fit lower control arms for a '68 Sprite. I'm told you sell just the bushings. Need a L and R set, inner and outer.
 
I'm using Apple to install and ream new bushings in my swivel axels for a Bugeye. Have used them several times over the years for shocks and kingpins. They've always done good work.

Kurt
 
Jim,

I purchased a Prothane set from Moss 280-938. They work great, nice and tight no squeaking and handles great.

I have done my whole car with these, price seems reasonable, I have seen a lot more expensive graphite and other sets out there.

Mark
 
I also have Prothane bushings on my Bugeye and have no real complaints. the only one I do have is with the trunnion bushings.....they seem to get wallowed out fairly quickly.

I have some delrin/hard plastic bushings too.....one day I may put those on to see if the car handles any differently.
 
Back
Top