Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Mark Jones
Jedi Warrior
Offline
I'm replacing the rear valance on my 80 Spitfire and am wondering
about how to remove the "lower edge trim" or "finisher" that covers
the seam between the valance and the rear fender.
Is this piece welded in place or is there a chance that it can be
pryed off? Any suggestions how to remove this piece?
Man, there are a lot of spot welds to be removed. I'm hopeing to get
the valance removed this weekend.
Thanks for the help.
about how to remove the "lower edge trim" or "finisher" that covers
the seam between the valance and the rear fender.
Is this piece welded in place or is there a chance that it can be
pryed off? Any suggestions how to remove this piece?
Man, there are a lot of spot welds to be removed. I'm hopeing to get
the valance removed this weekend.
Thanks for the help.