Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
memphis
Jedi Hopeful
Offline
Hello All!
The 2 wires connected to my rear license plate light are simply wrapped in electrical tape from the light to where they connect to the rear main harness in the trunk. Is this correct or is there a small harness (insulated) that should be used?
I want to add a fuse holder and fuse to the lic plate light, but before I do, want to make sure its all done the right way.
Thank you!
Bob
The 2 wires connected to my rear license plate light are simply wrapped in electrical tape from the light to where they connect to the rear main harness in the trunk. Is this correct or is there a small harness (insulated) that should be used?
I want to add a fuse holder and fuse to the lic plate light, but before I do, want to make sure its all done the right way.
Thank you!
Bob
