• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Rear backing plates

Share this page

Rut

Rut

Obi Wan
Offline
I replaced my rear backing plates with later ones and all went well. As I was connecting the new brake lines I noticed that I installed the plates with the nuts on the outboard side when they should have been on the inboard. There is no interference of any kind and everything is finished, should I take it all apart and reverse them?
Rut
 
If you are 100% sure there is no interference, then roll with it.
 
Trevor,
the completed rear end is still on the stand, but there is no interference. I had much rather redo it at this point vs on the car if there is any possibility of an issue. I replaced the bolts with grade 5 so there should be no issue with strength.
Rut
 
Back
Top