Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Offline
Can anyone with a 5 speed answer the following? I finally got back to Onslo the Sprite and bled the clutch again. I have a Datsun 5 speed with the Rivergate aftermarket slave cylinder. I kept the Sprite flywheel and a new Sprite clutch modified per Rivergate instructions. I got all the air out and the clutch feels right and it seems to disengage as it should. I have about an inch of free play at the pedal and maybe 1/16 inch at the release lever. Is that 1/16 enough to ensure the release bearing is not riding on the diaphram? I think there is enough pedal to back it off a little if that is too tight. I don't want to wear out the release bearing any sooner than absolutely necessary. Have not driven it yet but it will start in gear and select any gear with engine running. It will move forward and backward under its own power. Hope to test drive tomorrow.