-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Powder Coating Wire Wheels?
- Thread starter Tinkerman
- Start date
Share this page
MGTF1250Dave
Jedi Knight
Offline
Aloha Dick,
It may not be a good idea. You may need to periodically tune (adjust spoke tension) the wheel and powder coating may prevent the nipples from turning. If they can turn, it may break the coating on at the wheel rim or spoke. Also the spokes will be flexing constantly as you drive, this may also break the coating on the spoke. I am assuming that the powder coating forms a hard, brittle coating but I may be wrong.
It may not be a good idea. You may need to periodically tune (adjust spoke tension) the wheel and powder coating may prevent the nipples from turning. If they can turn, it may break the coating on at the wheel rim or spoke. Also the spokes will be flexing constantly as you drive, this may also break the coating on the spoke. I am assuming that the powder coating forms a hard, brittle coating but I may be wrong.
Online
A friend of mine did this years ago with the bolt-on wire wheels on his '72 Spitfire. They've held up very nicely!
Lou Metelko
Jedi Trainee
Offline
The shop that powder coated the wire wheels on the 4A had me sign a note that stated they were not responsible for any chipping or cracking of the coating. Sounded a mite harsh at the time but now ten years later a little soap and a brush returns the wheels to like new (no chips or cracks yet).
Lou Metelko
Auburn, Indiana
Lou Metelko
Auburn, Indiana
Silverghost
Yoda
Offline
A friend of mine had a 34 Rolls he was doing the wheels on and was considering powder coating. He was advised not to because while powder coating is durable, if you don't get every last spot coated, you leave the wheel vulnerable to rust which you won't see until it is too late. He went with paint.
TR3driver
Great Pumpkin - R.I.P
Offline
My wires are chrome/SS, but I can't see any reason powdercoat would be inferior in any way to paint. I've seen lots of PC'd wire wheels, and they usually look better than paint.
PC is actually less brittle than paint, tho it can be chipped with determination. But it seems to do fine on things that flex, even sway bars, coil springs and such.
Worst case, if you did find a spot that was missed, you could always touch it up with paint. It's even possible to redo the PC, although my only attempt so far didn't come out looking very good.
PC is actually less brittle than paint, tho it can be chipped with determination. But it seems to do fine on things that flex, even sway bars, coil springs and such.
Worst case, if you did find a spot that was missed, you could always touch it up with paint. It's even possible to redo the PC, although my only attempt so far didn't come out looking very good.