• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Pertronix problem

Share this page

J

Jerry

Darth Vader
Gold
Country flag
Offline
I installed a Pertronix unit in my negative ground TR3A this weekend. It is pretty simple install. I did check the wire connections (red to positive, black to negative). When I turned on the key, the white (from ignition) wire to the coil started to fry. Obviously a short. Any suggestions? I thought I would call the company this week and ask them. Model installed is LU142A

Thanks for your help.

Jerry
TR3A

[ 02-09-2003: Message edited by: Jerry ]</p>
 
Jerry,

Is it possible the red wire got nicked by the rotor inside the distrib and grounding on the base plate?

Apparently this is easily achieved.
savewave.gif
 
I installed a Pertronix in my Healey BJ8 a couple years ago. It initially did great - fired right up and sounded good. However, after about ten minutes failed. Upon very close inspection, noticed a small heat bubble. Supplier replaced with no questions and the replacement has done fine since. Good luck!
 
Back
Top