Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
So over the years I have lost count how many times I have removed the "bonnet" on my 66 Sprite for various repairs. Anyways I noticed last week that the bonnet, where it meets the bulkhead, is about a half an inch lower than the bulkhead. Is this something I can fix by placement of the washers under the two hinges where they attach to the bonnet and is there a trick to where you put the washers to raise the back of the bonnet?
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Odd Bonnet question
- Thread starter radibob
- Start date
Share this page
Jim_Gruber
Yoda
Offline
Cowl Seal, McGregor's in CA. See their ad in the back of Classic Motor Sports. Best to call, they don't respond well to e-mail but their rubber parts fit and are top notch.