Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
jlaird
Great Pumpkin
Offline
you guys may have seen this before?
Has anyone else had this prob? I just came back from a nice drive, lovely here sun out and high 60s.
Here is what I determined.
Below 3K RPM all is fine. From 3K to 4K clutch pedel is low but workable when shifting. Above 4K pedel will not release clutch.
I do have a 1275 slave push rod which is 2 11/16 long vs the 948, 1098 which is 2 1/2 inchs long. However, I would think that the longer one would be fine as the pedel is good other wise. But then is it? I can change out easly enough, not a problem. Do you think it makes any difference?
Has anyone else had this prob? I just came back from a nice drive, lovely here sun out and high 60s.
Here is what I determined.
Below 3K RPM all is fine. From 3K to 4K clutch pedel is low but workable when shifting. Above 4K pedel will not release clutch.
I do have a 1275 slave push rod which is 2 11/16 long vs the 948, 1098 which is 2 1/2 inchs long. However, I would think that the longer one would be fine as the pedel is good other wise. But then is it? I can change out easly enough, not a problem. Do you think it makes any difference?