-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR4/4A Need N/A part
- Thread starter shoopal
- Start date
Share this page
Offline
https://www.britishcarforum.com/bcf/showthread.php?94015-Source-for-air-duct-seal
That might help. Good timing on this, as I am (almost) approaching installing my dash!
That might help. Good timing on this, as I am (almost) approaching installing my dash!
I don't see a reply I submitted to this so I'll repeat it.
Check out this stuff called "Backer Rod" in 3/4" diameter. Cut a small channel down the length and fit it around the duct on the plenum side. A hot glue gun is ideal for attaching and holding the joint together. On the dash side, a gasket from thin rubber sheet should do the trick.
I haven't done this yet, but this is my plan
Check out this stuff called "Backer Rod" in 3/4" diameter. Cut a small channel down the length and fit it around the duct on the plenum side. A hot glue gun is ideal for attaching and holding the joint together. On the dash side, a gasket from thin rubber sheet should do the trick.
I haven't done this yet, but this is my plan
Rut
Obi Wan
Offline
I've replaced several and I buy my self adhesive wool felt and rubber weatherstrip on the internet...eBay, or do a search. The wool felt I use is rated at 7 I believe and the weatherstrip is 3/8" thick and 1" wide and I use weatherstrip adhesive to glue it to the outside and inside edge of the duct with at least 1/2" extended past the edge to form the seal. Iirc, the rubber is closed cell neoprene type.
Rut
Rut